Susan Deierling, Assoc. Broker
(928) 451-6098 mobile
Realty Executives Northern Arizona
Tag Archives: Plumbing
As a home buyer in Sedona , you can get a feel for whether a home’s systems and appliances are in working order. However, you can’t know for certain until after the home’s been inspected.
This is why real estate agents recommend that buyers hire a licensed home inspectors immediately after going into contract. It’s the best way to really know the home which you’re buying.
By definition, a home inspection is a top-to-bottom check-up of a home’s physical condition and systems, including a review of the structure, and its plumbing and electrical systems. Home inspections are not the same as a home appraisal, which is a valuation of the property.
When you commission a home inspection, you should be present for it. Here are 3 reasons why :
Seeing For Yourself
There’s a big difference between reading a report and seeing “live” what may be right or wrong with a home. With first-hand knowledge of a potential issue, you’ll be in a better position to determine whether a problem warrants contract cancellation, or whether it’s an additional negotiation point.
Discovering The Home
Via a home inspection, you will learn where the systems reside within a home (e.g.; boiler room, garage), and how to operate them. This is a valuable educational opportunity and most inspectors are happy to share what they know. It’s also a chance to ask questions about maintenance and upkeep.
A home inspector’s job is to review and disclose the condition of the home. The inspector’s report, however, is just a summary on paper. In being present for the inspection, a buyer will be able to visualize and understand the report’s conclusions more clearly. This can make for more effective re-negotiations with the seller, in the event that damage or distress is identified.
So, what should you do during the home inspection? Your primary tasks are to watch, listen, learn and ask questions. A professional home inspector will welcome your participation in the process.
Typically found at the tip of indoor water faucets, water aerators split a single water stream into droplets, slowing the overall water flow and reducing the degree of “splashing”.
Homes in Cornville with aerated faucets use up to 50% less water than homes without. However, aerated faucets can lose their effectiveness over time if they’re not cleaned at least periodically.
This is because aerators can collect and trap particles including minerals deposits and grit, depending on the make-up of your home’s water supply.
The good news is that cleaning your faucet aerator is a do-it-yourself job that requires no technical plumbing skills, and takes less than 5 minutes to complete.
Here’s how to clean your home’s water aerators.
First, close or cover the drain of your sink. This will prevent pieces or parts from getting lost. Then, unscrew the aerator from the tip of your faucet. You may be able to turn the aerator with your fingers. If you cannot, and need to use pliers, wrap the faucet with a towel to prevent damage to the faucet from the pliers.
Also, don’t squeeze harder than necessary — you may bend the aerator casing.
Next, on a small towel, separate the parts of the aerator and lay them flat.
Then, using your finger, poke the mesh filter out from the aerator, being careful not to bend it. Use tap water to rinse sediment from the filter or, in extreme build-up cases, place the filter in a small cup of vinegar, soak it for an hour, then clean it with a small brush.
At this point, your aerator is clean. Replace the parts as you found them, and twist the water aerator back onto the faucet tip. If you use pliers for this step, remember to protect your faucet’s finish with a towel.
There is no specific rule for how often an aerator should be cleaned. In some areas, it’s twice yearly. In other areas, it’s every 5 years. If you’ve never cleaned your water aerators, though, make today your first time.